Welcome to the Australian Ford Forums forum.

You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today!

If you have any problems with the registration process or your account login, please contact us.

Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated.

Go Back   Australian Ford Forums > Club and Speciality Forums > Ford Car Clubs > New and Classic Ford Association of Australia Inc

New and Classic Ford Association of Australia Inc A Queensland based club for all Ford models of all ages of Show “n” Shine standard.

Reply
 
Thread Tools Display Modes
Old 26-05-2017, 10:21 PM   #1
wanneroo
Regular Member
 
Join Date: May 2007
Posts: 85
Default Ecu

For many many months I have had problems with the EF fairmont not wanting to start after having been warmed up then standing for around 3hrs I had to press the throttle down to get her to start, I had the vehicle in to auto electricians three times and other mechanics they found no problems so they changed the injectors which I supplied plus an ignition bank a TPS module and mapping module plus an oxygen sensor complete set of ignition leads and plugs a new temperature sensor the ECU was also re coded
this cost me a fair bit of money, The fault had not shown up it was intermittent however it presented the same problem no one could find the issue it cleared
This week I got in my car and stated her she cut out each time I started her no idle at all I called the RAC they came and suspected a vacuum leak to no avail The car was put on the truck and taken to the RAC repair dept it was then taken to an auto electrical place where they diagnosed a faulty ECU I was quoted $600 to have this changed and all set up
I went today to collect the car paid the repairs I was very surprised she started like very quick and drove with a very responsive touch on the throttle she flew like never before she idled in Drive at 700rpm rock steady I am very impressed that the ECU could improve performance like this I am beginning to wonder if the ECU had been the problem all along with starting I don't all I know its like driving a new car I know my car well having had her many years but wow what a change to her running
wanneroo is offline   Reply With Quote Multi-Quote with this Post
Old 29-05-2017, 08:43 AM   #2
Dr Terry
FF.Com.Au Hardcore
 
Join Date: Jan 2011
Posts: 1,287
Default Re: Ecu

I'm surprised that you couldn't find an auto electrician more familiar with common Ford ECU problems.

I've been in the auto industry for 40+ years & these days do a lot of work in the EFI area.

Most cars' ECUs are very reliable, but every now & then we see regular failures on one particular model. Arguably the common failure with Ford ECUs (of all series) is the idle circuit in EF 6-cyls. This was definitely your problem all along.

With the idle circuit not working, you will get intermittent hard cold start, occasional stalling, worse in high load situations, i.e. A/C on, in drive, headlights on etc, etc. At one time, a few years ago we used to sell several of those units each week.

Dr Terry
Dr Terry is offline   Reply With Quote Multi-Quote with this Post
Old 29-05-2017, 12:29 PM   #3
snap0964
FF.Com.Au Hardcore
 
Join Date: Feb 2005
Location: Sth Coast NSW
Posts: 1,512
Default Re: Ecu

The EF idle driver is a common fail. Without the idle speed controller receiving signal from the ECU, they'll be no RPM pickup for all the various loads - normally with the car running, if you disconnect the plug from the ISC, the car should stall.
snap0964 is offline   Reply With Quote Multi-Quote with this Post
Old 29-05-2017, 12:52 PM   #4
wanneroo
Regular Member
 
Join Date: May 2007
Posts: 85
Default Re: Ecu

Thanks gentlemen for your comments tell me is it normal to idle higher at a cold start I took her out of my parking area parked up outside I noticed the RPM was running around 900 is this normal for a cold start I haven't been out in her yet just picked up your replies she was at 800rpm prior to the new ECU
wanneroo is offline   Reply With Quote Multi-Quote with this Post
Old 29-05-2017, 03:27 PM   #5
Dr Terry
FF.Com.Au Hardcore
 
Join Date: Jan 2011
Posts: 1,287
Default Re: Ecu

Quote:
Originally Posted by snap0964 View Post
The EF idle driver is a common fail. Without the idle speed controller receiving signal from the ECU, they'll be no RPM pickup for all the various loads - normally with the car running, if you disconnect the plug from the ISC, the car should stall.
Not quite, I've found that if you unplug the ISC, the revs should drop from 700 to around 600 at a warm idle in neutral & no A/C etc. If it stalls, then the throttle body needs a good clean or the base idle stop has been set too low.

Dr Terry
Dr Terry is offline   Reply With Quote Multi-Quote with this Post
Old 29-05-2017, 10:07 PM   #6
snap0964
FF.Com.Au Hardcore
 
Join Date: Feb 2005
Location: Sth Coast NSW
Posts: 1,512
Default Re: Ecu

Well, that's what I've found typically, and the cars are warm idling around 700 RPM with ISC disconnected and the feeler gauge in place, the few I've tested.

Quote:
Originally Posted by wanneroo View Post
Thanks gentlemen for your comments tell me is it normal to idle higher at a cold start I took her out of my parking area parked up outside I noticed the RPM was running around 900 is this normal for a cold start I haven't been out in her yet just picked up your replies she was at 800rpm prior to the new ECU
It's not unusual, the cold start/run tune of these cars is set quite rich - what's the idle when at normal op temp ?
snap0964 is offline   Reply With Quote Multi-Quote with this Post
Old 30-05-2017, 11:40 AM   #7
wanneroo
Regular Member
 
Join Date: May 2007
Posts: 85
Default Re: Ecu

My fairmont is still at around 900rpm on idle when warm and out of gear, I called the RAC who replaced the ECU they said to run it a few days for the new ECU to learn sounds a little weird maybe its correct ?
wanneroo is offline   Reply With Quote Multi-Quote with this Post
Reply

Thread Tools
Display Modes

Forum Jump


All times are GMT +11. The time now is 04:23 AM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Other than what is legally copyrighted by the respective owners, this site is copyright www.fordforums.com.au
Positive SSL