|
|
|
|
|
29-05-2007, 05:39 PM
|
#1 | ||
|
Regular Member
Join Date: May 2006
Location: Brisbane, Australia
Posts: 85
|
Well after a few hurdles and missed dates on shipments etc, I finally picked up my 9" today. The details are;
1. Sheet metal 9" housing made here in AUS by OzDiff 2. 31 Spline FOOTE axles with Strange screw in studs 3. Strange nodular pro iron carrier c/w Daytona Lge bearing pinion support, Lge Strange yoke & 3.9 Richmond gears. 4. EA/EB alloy calipers c/w DBA Xdrilled/Slotted rotors. You can see update photo's here http://s134.photobucket.com/albums/q...porty%20Corty/ |
||
|
|
|
30-05-2007, 01:10 AM
|
#2 | |||
|
Regular Member
Join Date: Jan 2006
Location: perth
Posts: 461
|
bung link mate...
__________________
Quote:
|
|||
|
|
|
|
30-05-2007, 07:17 PM
|
#3 | ||
|
Regular Member
Join Date: May 2006
Location: Brisbane, Australia
Posts: 85
|
[QUOTE=351clevocorty]Well after a few hurdles and missed dates on shipments etc, I finally picked up my 9" today. The details are;
1. Sheet metal 9" housing made here in AUS by OzDiff 2. 31 Spline FOOTE axles with Strange screw in studs 3. Strange nodular pro iron carrier c/w Daytona Lge bearing pinion support, Lge Strange yoke & 3.9 Richmond gears. 4. EA/EB alloy calipers c/w DBA Xdrilled/Slotted rotors. You can see update photo's here Try this now http://s134.photobucket.com/albums/q...porty%20Corty/ |
||
|
|
|
|
31-05-2007, 01:21 PM
|
#4 | ||
|
FF.Com.Au Hardcore
Join Date: Apr 2005
Location: NorthWest, Sydney
Posts: 2,132
|
Nice Diff. :P
Brings back memories of my TE cortina that had a 9 inch diff. What next in the project?? |
||
|
|
|
|
03-06-2007, 09:22 AM
|
#5 | |||
|
Regular Member
Join Date: May 2006
Location: Brisbane, Australia
Posts: 85
|
Get it back rolling
Final engine gearbox alignment Check header clearance and adjust where necessary Make up full length chassis connector Roll cage? Haven't decided yet Paint engine bay Run new brake lines Quote:
|
|||
|
|
|
Update Project TF Cortina - Sheet Metal 9" Complete
Linear Mode
