|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
18-05-2011, 02:13 AM
|
#91 | ||
|
Starter Motor
Join Date: Aug 2008
Posts: 20
|
WOW, i have a front main seal leak, i hope i dont have to go through what you have gone through. I dont have a spare vehicle to get around :-(
My engine is the same as yours VCT in a SII Fairlane :shock: |
||
|
|
|
18-05-2011, 02:12 PM
|
#92 | ||
|
rexnet
Join Date: Feb 2010
Location: Whybother, South Australia
Posts: 3,557
|
Mine was a really unlucky case of some moron! doing something dodgy and not fixing it properly.
You need a big puller. Take our rad and thrmo's old balancer isnt a big deal to get off. Replace it. Getting the seal in can take some time tho. Put a bit of oil on it to lubricate it. Other then that your all right. Also just watch your puller teeth. Make sure it doesn't brake the TDC marker |
||
|
|
|
Re: Replacing front crank seal and fitting speedy sleeve to hamonic balancer
Linear Mode
