|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
29-09-2005, 07:58 PM
|
#1 | ||
|
Turbo Falcon Fiend
Join Date: May 2005
Location: Far West NSW
Posts: 3,203
|
Just a peice of next to useless information. I picked up my new AU motor for the taxi today - in the taxi.
An AU6 long bare motor on a timber base fits into the boot of an AU sedan. I might have looked a bit silly, but it saved me another trip (150k's return) in my ute. The length of the rocker cover is about 28 inches and the boot is between 41 and 46 inches. The motor has 104k on it and looks pretty good. I am removing and replacing on the weekend. Has anyboyd done this swap before and if so does anybody have any tips for me? I have only done older motors before and manuals - never a late model and never an auto. Any help would be appreciated. Ta |
||
|
|
|
29-09-2005, 08:12 PM
|
#2 | ||
|
FF.Com.Au Hardcore
 
Join Date: Dec 2004
Posts: 12,083
|
Dont use Occie straps to lift it...
 :(Sorry, was too easy, had to take it)
__________________
Older, wiser, poorer. Now in Euro-Trash. VW Coupe V6 4motion.
|
||
|
|
|
|
29-09-2005, 08:13 PM
|
#3 | ||
|
they call me Tibbo
Join Date: Dec 2004
Location: Brisbane
Posts: 6,163
|
leave the trans in the car, pull the engine out complete and swap the auxcilleries over before you put the new engine in.
__________________
|
||
|
|
|
|
29-09-2005, 08:41 PM
|
#4 | ||
|
Turbo Falcon Fiend
Join Date: May 2005
Location: Far West NSW
Posts: 3,203
|
Yeah I had that bit sussed out.
I am a little lost with the whole convertor thing, as I understand it, I remove the dust cover, undo the 4 bolts on the back of the convertor, slide it towards the trans. Undo bellhousing. Undo the rear mount on the trans slide whole trans back. Does this sound right? |
||
|
|
|
|
29-09-2005, 08:52 PM
|
#5 | ||
|
they call me Tibbo
Join Date: Dec 2004
Location: Brisbane
Posts: 6,163
|
leave the convertor in there, just undo the bolts thru the inspection plate and pull the engine out
__________________
|
||
|
|
|
AU6x2 under the bonnet and in the boot - any tips for engine swap on the weekend???
Linear Mode
