|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
06-11-2007, 09:38 PM
|
#1 | ||
|
Starter Motor
Join Date: Sep 2006
Posts: 4
|
Hi,
any help with this would be greatly appreciated. i am currently in the process of doing up at 4dr mk2 turning it from a 1600 to a 2L i have put 45 webber side draughts on it but unfortunately cannot come up with a way to connect the throttle cable. What do people normally do? Thankyou Taco |
||
|
|
|
06-11-2007, 11:27 PM
|
#2 | ||
|
Mk2 rs2000
Join Date: May 2005
Location: melb
Posts: 18
|
hey dude,
just did the same thing, with dellorto's :P I took the back engine lift backet and welded the top part off the orginal backet for the cabel. so the cabel sits at the back on the engine and joints onto the linkage kit. I could get pics, but the car is in storage, so it will be later in the week. These are low quality pics |
||
|
|
|
|
07-11-2007, 12:41 AM
|
#3 | ||
|
Starter Motor
Join Date: Sep 2006
Posts: 4
|
thanks for the quick reply im going to source out a new cable tomorrow and try it out. but if you could post those other pics you were talking about it would be even better. thanks again
|
||
|
|
|
MK2 2L accelorator cable
Linear Mode
