Re: Fitting new disks wiht dial indicator gauge?
|
|
Good questions and good answers there.
We did a tour of DBA's facilities at Silverwater some years ago and they would actually pull rotors off production and check runout in a temperature controlled room on a measuring tool worth thousands of dollars and get a printout. On the other hand there would be other manufacturers that wouldn't go to that extreme.
I have been in the industry quiet a few years and really the amount of new rotors i have seen that have any runout to be concerned with is very minimal but fitting them on used bearing hubs are a different story so if you have the tools and the time then why not do it.
__________________
|