Hi everyone,
need input, would be greatly appreciated
Well got the bar today, went to install it and the bar ends are at a different angle.
The bar's dimensions are the same only thing is, is that the eyes on the end that connect to the subframe are at a 90deg angle and need to be at a 45deg angle.
Do you think it would be ok to take it to someone, being Industrial Springs on Port Rd for the ppl in SA, who can heat the bar and turn the ends to where it should be? Or would it be ok for them to cut near the ends and reweld them where I need them to be.
Not worried about warrany issues just concerned about the strength of the bar after doing this.
Appreciate everyones input and concers.
p.s. yes I'm a little ****ed but it was a 50/50 chance it would fit.
Cheers
|