Some of my detailed drawings for the MTX75 passenger side mount to fit in a Fiesta.
This is all drawn on 1mm line paper, but I lost my drafters alphabet stencil so I haven't dimensioned it. There are some hand written numbers on it.
The bracket itself is intended to be made with 5mm x 150mm wide flat bar and 30mm rod. Requires welding. The Rod needs to be drilled in both cases, but the upright needs to be tapped to m12x1.75.
THIS IS YET TO BE BUILT, so while I have cleared the MTX75 breather and speedo connector, I have yet to confirm if there are any other conflicts.
Top View
View from front of car
View from Passenger side of car
Luke