|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
| The Bar For non Automotive Related Chat |
 |
|
|
Thread Tools | Display Modes |
14-01-2018, 09:04 PM
|
#1 | ||
|
Starter Motor
Join Date: Feb 2013
Posts: 12
|
How do i and how many door sill panels do i need to remove to run my wires.I will also run a seperate charge wire for my engle fridge stay safe mal b
|
||
|
|
|
15-01-2018, 08:46 AM
|
#2 | ||
|
Chairman & Administrator
  
Join Date: Dec 2004
Location: 1975
Posts: 106,563
|
Wiring should be run through the sills on the right hand side and then pull the back right side plastics in the rear compartment apart and run the wiring through there all the way to behind the tail light and then follow the existing cabling to underneath the car from there.
Use a single 8mm wire for the fridge, and a similar one for the brake controller. The factory trailer plug has a wire for a brake controller (blue) but stupidly it doesn't go to the front of the vehicle - it only runs from the socket to the connector behind the tail light cavity. On the plus side, those wanting to charge a battery will find that will find that Pins 9&10 on the trailer plug carry a battery feed and earth to do so.
__________________
 Observatio Facta Rotae
|
||
|
|
|
|
16-01-2018, 07:54 AM
|
#3 | ||
|
Regular Member
Join Date: May 2008
Location: Lake Macquarie
Posts: 228
|
Russell,
is the rear power feed (pins 9/10), connected to a acc relay or is it direct power? Also picking up the brake signal for the brake controller is it OK to use the pedal switch? or recommended to use the tail light signal. thanks,
__________________
... |
||
|
|
|
Wire tx sy awd for electric brakes
Linear Mode
