Re: Engine build advice - general
|
|
whilst on liners
a little trick i was taught in removing them if you dont have a puller to do so is to run stick welds up the bore thus shrinking the liner when its cooled and helps to remove
the bloke that showed me this had me doing a rebuild on his 8t isusu truck as a back yard rebuild after i told him he'd need the puller to do the job as thus was the way i was originally taught
and with polishing crank journals we used (when i was doing my trade at the railways) a leather strap like used in/for cut throat razors either by hand with the crank held still and dragging the strap back and forth or rotating the crank whilst holding the strap
__________________
yes still (as money n time permit) doing the
rebuilding the zh fairlane with a clevo 400m 4v heads injected whipple blown with aode 4 speed trans to a 9" ....... we'll get there eventually
just remember don't be afraid to try something new.
Remember, amateurs built the Ark...Professionals built the Titanic!
I have taken up meditation... at least it's better than sitting around doing nothing !!
|